Yamaha WR450F Owner's Manual page 21

ton together again.
TIP
The stopwatch will continue counting
when the vehicle is stopped. To stop
and/or resume counting, repeat steps 3
and 4.
Measurement mode (for calibrating
the distance-compensation tripme-
ter's reading)
The distance-compensation tripmeter
is a feature intended to provide a more
accurate tripmeter reading for enduro
riding. Calibrating this meter in accor-
dance with the distances specified on
the enduro course map will help famil-
iarize the rider with the course. In addi-
tion, calibrating the meter may also be
necessary when using tire, wheel,
chain sprocket sizes, etc. other than
specified. For further information con-
cerning the use of this meter, please
consult your nearby Yamaha dealer.
Calibrate the distance-compensation
tripmeter as follows.
To increase the reading, push the
"SLCT 1" button. To decrease the read-
ing, push the "SLCT 2" button. Pushing
INSTRUMENT AND CONTROL FUNCTIONS
and holding either button will increase
or decrease the reading continuously
until the button is released.
TIP
Calibrating the reading of the dis-
tance-compensation tripmeter is possi-
ble regardless of the
operation.
Resetting the distance-compensa-
tion tripmeter or the distance-com-
pensation tripmeter in combination
with the stopwatch
TIP
Resetting can be made only to the dis-
tance-compensation tripmeter or to the
distance-compensation tripmeter
combination with the stopwatch.
Resetting the distance-compensation
tripmeter
1. Check that the stopwatch mea-
surement is in operation.
2. Reset the distance-compensation
tripmeter to zero by pushing the
"RST" button for at least two sec-
onds.
3-6
Resetting the distance-compensation
tripmeter in combination with the stop-
watch
1. Stop the stopwatch.
2. Reset the distance-compensation
tripmeter and the stopwatch to
zero by pushing the "RST" button
stopwatch
for at least two seconds.
in
2
3
4
5
6
7
8
9