Yamaha SUPER TENERE XT1200Z Owner's Manual page 29

Traction control system mode dis-
play
1
1. Traction control system mode display
This display indicates which traction
control system mode has been select-
ed: "1", "2" or "Off". For more details on
the modes and on how to select them,
refer to page 3-21.
INSTRUMENT AND CONTROL FUNCTIONS
Self-diagnosis device
1 2 3
1. Engine trouble warning light "
2. Immobilizer system indicator light
3. Error code display
This model is equipped with a self-diag-
nosis device for various electrical cir-
cuits.
If a problem is detected in any other cir-
cuit, the engine trouble warning light
comes on and the display indicates an
error code.
If the display indicates any error codes,
note the code number, and then have a
Yamaha dealer check the vehicle.
If a problem is detected in the immobi-
lizer system circuits, the immobilizer
system indicator light flashes and the
display indicates an error code.
3-14
TIP
If the display indicates immobilizer sys-
tem circuit error code 52, this could be
caused by transponder interference. If
this error code appears, try following
the procedure below.
1. Use the code re-registering key to
start the engine.
TIP
"
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
2. If the engine starts, turn it off and
try starting the engine with the
standard keys.
3. If one or both of the standard keys
do not start the engine, take the
vehicle, the code re-registering
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.
3