Chapter 17 Installing Options; Removing The Bottom Case; Dru-3A Digital Recording Unit; Vs-3 Voice Synthesizer Unit - Kenwood TS-2000 Instruction Manual

INSTALLING OPTIONS
You will require a Phillips screwdriver when installing
the optional units.

REMOVING THE BOTTOM CASE

When installing the optional DRU-3A or VS-3 unit,
remove the bottom case first.
1 Remove the 10 screws.
2 Lift off the bottom case.

DRU-3A DIGITAL RECORDING UNIT

SWITCH OFF THE POWER AND UNPLUG THE DC POWER
CABLE BEFORE BEGINNING INSTALLATION.
1 Remove the bottom case (10 screws).
2 Locate the DRU-3A connector.
3 Peel off the paper on the cushion attached to the
PC board of the transceiver.
Cushion
4 Plug the DRU-3A into the DRU-3A connector of
the PC board.
5 Press the top of the DRU-3A to affix it to the
cushion.
DRU-3A
6 Replace the bottom case (10 screws).
Note: After the installation, you can adjust the DRU-3A playback
volume by selecting Menu No. 14.

VS-3 VOICE SYNTHESIZER UNIT

SWITCH OFF THE POWER AND UNPLUG THE DC POWER
CABLE BEFORE BEGINNING INSTALLATION.
1 Remove the bottom case (10 screws).
2 Locate the VS-3 jack.
3 Hold the VS-3 unit with the component side facing
up, and insert the VS-3 connector into the VS-3
jack.
4 Replace the bottom case (10 screws).
Note: After the installation, you can adjust the VS-3 playback volume
by selecting Menu No. 15.
97