Adjusting The Detail Of Audio Control; Audio Setup - Kenwood KDC-BT7043U Instruction Manual

Adjusting the detail of Audio Control

You can adjust the following Basic Audio Items in
datail: Bass level, Middle level, and Treble leval.
Bass level
Adjustment Item Display
Bass Center Frequency "BASS F"
Bass Q Factor "BASS Q"
Bass Extend "BASS EXT"
Middle level
Adjustment Item Display
Middle Center Frequency "MID F"
Middle Q Factor "MID Q"
Treble level
Adjustment Item Display
Treble Center Frequency "TRE F"
1
Select the Basic Audio item
For how to select Basic Audio items, see <Audio
Control> (page 18).
2
Enter Detail adjustment mode of Audio
Control
Press the [AUD] knob for at least 1 second.
3
Select the Detail Audio item to adjust
Press the [AUD] knob.
4
Adjust the Detail Audio item
Turn the [AUD] knob.
5
Exit the Detail Audio Control mode
Press the [AUD] knob for at least 1 second.
⁄
• When you set the Bass Extend to ON, low frequency
response is extended by 20%.
• You can exit the Audio Control mode at anytime by
pressing any button except for [AUD] knob or
button.
Range
40/50/60/70/80/100/
120/150 Hz
1.00/1.25/1.50/2.00
OFF/ON
Range
0.5/1.0/1.5/2.0 kHz
1.0/2.0
Range
10.0/12.5/15.0/17.5 kHz
[0]

Audio Setup

You can set Sound system , such as follows;
Adjustment Item Display
Front High Pass Filter "HPF F"
Rear High Pass Filter "HPF R"
Low Pass Filter "LPF SW"
Subwoofer Phase "SW PHASE"
Volume offset "V-OFFSET"
Dual Zone System "2ZONE"
⁄
• Volume offset: Sets each source's volume as a difference
from the basic volume.
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by "ZONE2" of
<Function Control> (page 6).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [AUD] knob.
- Adjust the volume of Rear channel by <Audio Control>
(page18) or [5]/[∞] button on the remote control
(page 28).
- The Audio Control has no effect on sub source.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [AUD] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [AUD] knob.
4
Adjust the Audio setup item
Turn the [AUD] knob.
5
Exit Audio Setup mode
Press the [AUD] knob for at least 1 second.
Range
Through/40/60/80/100/120/
150/180/220 Hz
Through/40/60/80/100/120/
150/180/220 Hz
50/60/80/100/120/ Through
Hz
Reverse (180°)/ Normal (0°)
–8 — ±0 (AUX: -8— +8)
OFF/ON
19
|
English