Kenwood KDC-BT7043U Instruction Manual page 32

Appendix
• DISPLAY
If this unit is not operated at least 5 seconds with "OFF"
selected, the display turns off. During a setup mode,
the display will not turn off even if 5 seconds lapse.
• DVC STATUS (Displaying the Bluetooth device
Status)
You can display the connection status, signal
strength, and battery level.
: Battery level of cell-phone.
Full
: Signal strength of cell-phone.
Maximum
⁄
• Icons are not displayed if information cannot be
obtained from the cell-phone.
• Since the number of steps of the control unit is different
from that of the cell-phone, the statuses displayed on
the control unit may discord from those displayed on
the cell-phone.
• MIC GAIN
Adjusts the sensitivity of the built-in microphone
for a telephone call. Adjust the voice of caller.
Setting to "+" increases the voice volume.
• NR LEVEL
Reduces the noises generated by surrounding
environment without changing the built-in
microphone volume. Adjust the voice of caller
when it is not clear. Setting to "+" increases the
noise reduction.
• SP SEL (Setting up the Voice Output Speakers)
You can specify the voice output speakers.
"FRONT" : Outputs voice from the front-left and
front-right speakers.
"F-R" : Outputs voice from the front-right speaker.
"F-L" : Outputs voice from the front-left speaker.
⁄
• Select the speaker which is further from the microphone
in order to prevent howling or echoes.
• SUPREME
Technology to extrapolate and supplement with
proprietary algorithm, the high-frequency range
that is cut off when encoding at low bit rate (less
than 128Kbps, Sampling frequency is 44.1kHz).
Supplementing is optimized by compression
format (AAC, MP3 or WMA) and processed
according to bit rate.
The effect is negligible with music that is encoded
at high bit rate, variable bit rate or has minimal high
frequency range.
• ZONE2 (Dual Zone)
Set the destination (front speaker "FRONT" or rear
speaker "REAR") of the sub source (AUX IN) when
the Dual Zone function is turned on.
32
|
KDC-BT7043U/ KDC-MP6043U
The marking of products using lasers
(Except for some areas)
The label is attached to the chassis/case and says
that the component uses laser beams that have been
classified as Class 1. It means that the unit is utilizing
Nearly dead
laser beams that are of a weaker class. There is no
danger of hazardous radiation outside the unit.
Minimum
• The "AAC" logo is a trademark of Dolby Laboratories.
• The Bluetooth word mark and logos are owned by
• iPod is a trademark of Apple Inc., registered in the U.S.
• iPhone is a trademark of Apple Inc.
• "Made for iPod" means that an electronic accessory
• "Works with iPhone" means that an electronic
Apple is not responsible for the operation of this device
or its compliance with safety and regulatory standards.
CLASS 1
LASER PRODUCT
the Bluetooth SIG, Inc. and any use of such marks
by Kenwood Corporation is under license. Other
trademarks and trade names are those of their
respective owners.
and other countries.
has been designed to connect specifically to iPod and
has been certified by the developer to meet Apple
performance standards.
accessory has been designed to connect specifically
to iPhone and has been certified by the developer to
meet Apple performance standards.