Table of Contents
Advertisement
11/05/07 10:13:10 32KVCC00_091
5.
Check the clearance of both valves by
inserting a feeler gauge ( ) between the
adjusting screw ( ) and the valve stem.
9
Clearance should be:
Intake:
0.08 mm (0.003 in)
Exhaust:
0.12 mm (0.005 in)
6.
If it is necessary to make an adjustment,
loosen the adjusting screw lock nut (
and turn the adjusting screw so there is a
slight resistance when the feeler gauge is
inserted.
7.
After completing the adjustment, tighten
the adjusting screw lock nut while
holding the adjusting screw to prevent it
from turning.
Adjusting screw lock nut torque:
14 N·m (1.4 kgf·m , 10 lbf·ft)
8.
Finally, recheck the clearance to make
sure that the adjustment has not been
disturbed. Reinstall the cylinder head
cover, timing mark hole cap and the
crankshaft hole cap.
9.
Install the remaining parts in the reverse
order of removal.
If a torque wrench is not used for this
8
installation, see your dealer as soon as
possible to verify proper assembly.
10
)
(10)
(8) Feeler gauge
(9) Adjusting screw
(10) Adjusting screw lock nut
(9)
(8)
81
Hide quick links:
Advertisement
Table of Contents
