Honda GLH125 SH Owner's Manual page 108

11/05/07 10:15:40 32KVCC00_108
Rear Wheel Installation
1. Install the side collars into the left and
right side wheel hub.
2. Tighten the rear axle nut and brake
stopper arm nut to specified torque.
Rear axle nut torque:
68 N·m (6.9 kgf·m , 50 lbf·ft)
Brake stopper arm nut torque:
10 N·m (1.0 kgf·m , 7 lbf·ft)
3. Adjust the brake (page
chain (page 84 ).
4. After installing the wheel, apply the brake
several times and check for free wheel
rotation when released.
A used cotter pin may not effectively secure
a fastener. Always replace a used cotter pin
with a new one.
98
If a torque wrench is not used for
installation, see your dealer as soon as
possible to verif y proper assembly.
Improper assembly may lead to loss of
braking capacity.
26 ) and drive