Operation And Important Riding Points; Starting And Warming Up A Cold Engine; Starting A Warm Engine - Yamaha PW50 Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS

Read the Owner's Manual carefully to
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
Failure to familiarize yourself with
the controls can lead to loss of con-
trol, which could cause an accident
or injury.
6
EAU15951
Starting and warming up a
cold engine
1. Turn the fuel cock lever to "O" (on).
2. Set the engine stop switch to
"START".
EWA10271
3. Turn the starter (choke) on and
completely close the throttle. (See
page 4-7.)
4. While applying the front or rear
brake, start the engine by pushing
the kickstarter lever down.
5. After starting the engine, move the
starter (choke) back halfway.
6. When the engine is warm, turn the
starter (choke) off and set the en-
gine stop switch to "RUN".
TIP
The engine is warm when it responds
quickly to the throttle with the starter
(choke) turned off.
NOTICE
For maximum engine life, never ac-
celerate hard when the engine is
cold!
EAU40889

Starting a warm engine

Follow the same procedure as for start-
ing a cold engine with the exception
that the starter (choke) is not required
when the engine is warm. Instead, start
the engine with the throttle slightly
open.
TIP
If the engine does not start after several
kicks, try again with the throttle 1/4 to
1/2 open.
ECA11042
6-1
EAU16660