Install Steam-N-Chips Smoker; Add Cooking Grates - Weber Summit 425 NG Step-By-Step Manual

INSTALL STEAM-N-CHIPS
SMOKER
You will need: Steam-N-Chips smoker.
Remove the center Flavorizer bar (the one that is not over
a burner). Set the handles of the Steam-N-Chips smoker
on the Flavorizer bar holder. Figure 5 (a).
Note: For directions on how to use the Steam-N-Chips
smoker, see the Operating Guide.
a)
Summit 625 or Summit 650
Summit 425 or Summit 450
Figure 5

ADD COOKING GRATES

You will need: two (Summit 425 or 450) or three
(Summit 625 or 650) cooking grates.
The cross-wire of the cooking grate goes down. Set the
cooking grates in place next to each other. Figure 6.
INSTALL WARM-UP RACK
You will need: warm-up rack.
Install one end of the warm-up rack into the hole on the
right end of the lid and the other end into the slot in the
left end of the lid. Figure 7 (a).
a)
6
Figure 6
Figure 7