Weber Summit 425 NG Step-By-Step Manual
Weber Summit 425 NG Step-By-Step Manual

Weber Summit 425 NG Step-By-Step Manual

Natural gas barbecues
Hide thumbs Also See for Summit 425 NG:

Advertisement

Quick Links

Summit 425 NG
Summit 450 NG
CANADIAN GAS ASSOCIATION
A P P R O V E D
R
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. Open lid.
4. If odor continues, Keep away from the
appliance and immediately call your
gas supplier or your fire department.
Leaking gas may cause a fire or explosion
which can cause serious bodily injury or
death or damage to property.
1. Do not store spare LP Cylinder within
10 feet (3m) of this appliance.
2. Do not store or use gasoline or other
flammable liquids or vapors within 25
feet (8m) of this appliance.
SUMMIT
SUMMIT
®
DANGER
WARNING
TM
TM
Natural Gas Barbecues
Step-By-Step Guide
W
Summit 625 NG
Summit 650 NG
WARNING: Follow all leak check procedures
carefully in this manual prior to barbecue
operation. Do this even if barbecue was
dealer assembled.
NOTICE TO INSTALLER: These instructions
must be left with the owner and the owner
should keep them for future use.
THIS GAS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY.
WARNING: Do not try to light this appliance
without reading "Lighting" instructions
section of this manual.
425 & 625
450 & 650
92773
10/98

Advertisement

Table of Contents
loading

Summary of Contents for Weber Summit 425 NG

  • Page 1 SUMMIT 425 & 625 SUMMIT 450 & 650 Natural Gas Barbecues Step-By-Step Guide Summit 425 NG Summit 625 NG Summit 450 NG Summit 650 NG CANADIAN GAS ASSOCIATION ® A P P R O V E D WARNING: Follow all leak check procedures...
  • Page 2: General Specifications For Piping

    INSTALL GAS SUPPLY (CART INSTALLATIONS ONLY) General Specifications for Piping Typical natural gas supply installation. Figure 1. Gas supply Note - Contact your local municipality for building Inside wall codes regulating outdoor gas barbecue installations. In absence of Local Codes, you must conform to the latest edition of ANSI Z223.1.
  • Page 3: Tools Needed

    (11) (Summit 625 or 650) While we give much attention to our products, unfortunately an occasional error may occur. If a part is missing, do not go back to the store. Call the Weber Steam-N-Chips smoker Customer Service Center toll free 1-888-33-SUMMIT Note: If you use the Steam-N- (1-888-337-8664) to receive immediate assistance.
  • Page 4 REMOVE PACKAGED INSTALL “U” RAILS CONTENTS (CONTINUED) Note: lock the casters before starting assembly. You will need: two “U” rails, eight 1/4-20 x 1/2 inch bolts, Stainless steel bottom shelves eight nylon washers, and a 7/16 inch or adjustable wrench. (For Summit 425 and 625) Insert the tabs of the “U”...
  • Page 5: Install Flavorizer Bars

    CONNECT FLEXIBLE INSTALL FLAVORIZER HOSE TO REGULATOR BARS You will need: the 12 foot natural gas supply hose and a You will need: seven (Summit 425 or 450) or eleven 3/4 inch or adjustable wrench. (Summit 625 or 650) flavorizer bars Thread fitting end of hose onto regulator.
  • Page 6: Install Steam-N-Chips Smoker

    INSTALL STEAM-N-CHIPS ADD COOKING GRATES SMOKER You will need: two (Summit 425 or 450) or three (Summit 625 or 650) cooking grates. You will need: Steam-N-Chips smoker. The cross-wire of the cooking grate goes down. Set the Remove the center Flavorizer bar (the one that is not over cooking grates in place next to each other.
  • Page 7: Install Bottom Tray

    INSTALL BOTTOM TRAY Slide the bottom tray into the mounting slots under the bottom of the cooking box with the finger grip of the catch pan toward you. Figure 15. You will need: Bottom tray, catch pan holder, catch pan, and one drip pan.
  • Page 8: Install Bottom Shelves

    INSTALL BOTTOM INSTALL CONDIMENT SHELVES HOLDERS AND WORK SURFACES For the Summit 425 or 625, place the stainless steel bottom shelves between the frame supports. You will need: two condiment holders, two stainless steel For the Summit 450 and 650, place the bottom rack under work surfaces, and four wing nuts.
  • Page 9: Check For Gas Leaks

    Put your fingers under the front edge of the control panel, lift up, and pull evenly toward you. Figure 15 (a). WARNING Front edge of the The gas connections of your Weber Gas control panel Barbecue have been factory tested. We do however recommend that you leak check all gas connections before operating your Weber Gas Barbecue.
  • Page 10 CHECK FOR GAS LEAKS (CONTINUED) DANGER Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. This will result in a fire or explosion which can cause serious bodily injury or Manifold death and damage to property.
  • Page 11: Reinstall Front Panel

    Hose to regulator connection. Figure 18 (b). You will need: front panel. b) Hose to quick disconnect connection. Figure 18 (a). With the Weber logo to the left, slide front panel down into place. Figure 19. WARNING: If there is a leak at connections 17 (a), 17 (b), 17 (c) 18 (a), or 18 (b) turn OFF the gas.
  • Page 12: Install Tool Holders

    INSTALL TOOL HOLDERS REINSTALL CONTROL PANEL You will need: four tool holders. Place the tool holder under the control panel and over the You will need: control panel. front panel. Figure 20 (a). Set the tool holder on top of the Pull igniter buttons up until they stay in the up position.
  • Page 13: Reinstall Burner Control Knobs

    REINSTALL BURNER CONTROL KNOBS You will need: four (Summit 425 or 450) or six (Summit 625 or 650) burner control knobs. Push on the burner control knobs. Figure 22. Figure 22 REFER TO OPERATING GUIDE BEFORE LIGHTING BARBECUE...
  • Page 14 EXPLODED VIEWS FOR SUMMIT 425 NG 12-16...
  • Page 15 Igniter wire (black) (2) unfortunately an occasional error may occur. If a part is Gas catcher ignition chamber (2) missing, do not go back to the store. Call the Weber Manifold assembly Customer Service Center toll free 1-888-33-SUMMIT Manifold mounting clips (2) (1-888-337-8664) to receive immediate assistance.
  • Page 16 EXPLODED VIEWS FOR SUMMIT 450 NG 11-15...
  • Page 17 Manifold assembly Manifold mounting clips (2) unfortunately an occasional error may occur. If a part is Control panel missing, do not go back to the store. Call the Weber Igniter button (2) Customer Service Center toll free 1-888-33-SUMMIT Front panel (1-888-337-8664) to receive immediate assistance.
  • Page 18 EXPLODED VIEWS FOR SUMMIT 625 NG 14-18...
  • Page 19 Crossover tube (3) unfortunately an occasional error may occur. If a part is Left burner (3) missing, do not go back to the store. Call the Weber Right burner (3) Customer Service Center toll free 1-888-33-SUMMIT Burner control knob (6) (1-888-337-8664) to receive immediate assistance.
  • Page 20 EXPLODED VIEWS FOR SUMMIT 650 NG 14-18...
  • Page 21 Igniter wire (white) (3) unfortunately an occasional error may occur. If a part is Gas catcher ignition chamber (3) missing, do not go back to the store. Call the Weber Manifold mounting clips (2) Customer Service Center toll free 1-888-33-SUMMIT Manifold assembly (1-888-337-8664) to receive immediate assistance.

This manual is also suitable for:

Summit 450 ngSummit 625 ngSummit 650 ng

Table of Contents