Configuring The Display Of Name Information - American Dynamics RAS915LS Operator's Manual

Figure 5-5 represents pointing the dome precisely at 225° from North (Southwest) with a tilt of 25°
below the virtual horizon. Panning to the left points the dome towards the South. Panning to the right
points the dome towards the West.
Figure 5-5: Pointing the dome precisely southwest with a tilt elevation of –25°
Changing the Display of Direction Indicators
1. Select On-Screen Text Display from the Dome Configuration Menu.
2. Move the highlight to Direction Indicator.
3. Change the setting.
•
Select On to display the direction information.
•
Select Off to prevent the direction information from displaying.
The default setting is Off.
4. Select Exit. The Dome Configuration Menu appears. Continue with What To Do Next on page
5–11.

Configuring the Display of Name Information

Use the Name Configuration Menu to select which name information appears on-screen. To
display this screen, select Name Configuration Menu from the On-Screen Text Display screen.
The following screen appears:
You can choose to enable or disable the display of camera, area, preset, pattern, and alarm names
from this screen. You can reset all programmable names to their default settings. You may also
initiate name programming from this screen. See Assigning or Changing Name Information on
page 5–7.
5–6
S SW
-25
NAME CONFIGURATION MENU
CAMERA NAME
AREA NAME
PRESET NAME
PATTERN NAME
ALARM NAME
FOCUS FAR to program names
RESET PROGRAMMABLE NAMES
EXIT
W
ON/OFF
ON/OFF
ON/OFF
ON/OFF
OFF/ON
SpeedDome Ultra VII Operator's Manual