Invacare 9000 SL User Manual page 63

Installing Anti-Tippers
1. Remove plug button (not shown) from end of rear frame
tubing and install anti-rattles if not already installed.
2. Press the release buttons in and insert the anti-tippers with the
anti-tipper wheels pointing toward the ground/floor into the rear
frame tubing until the bottom release button locks in place.
3. Measure the distance between the bottom of the anti-tipper wheels
and the ground/floor.
A 1½ to 2-inch clearance between the bottom of

the anti-tipper wheels and the ground/floor MUST
be maintained at all times.
4. If the distance between the bottom of anti-tipper wheels and the ground/floor is not 1½ to 2-inches, adjust anti-tippers. Refer to Adjusting
Anti-Tippers on page 63.
Adjusting Anti-Tippers
1. Press the release buttons on the wheeled portion of the anti-tipper and slide it up or down to achieve the 1-1/2 to 2-inch clearance (Detail "A").
2. Check to make sure that the release buttons are fully engaged in adjustment holes.
1½ inches
Part No. 1056953
DETAIL "A"
Release Buttons
2 inches
FIGURE 2 Adjusting Anti-Tippers
10 ANTI-TIPPERS/WHEEL LOCKS
Anti-Tipper
Wheels
Anti-Tipper
FIGURE 1 Installing Anti-Tippers
Anti-Tipper
Height
63
Anti-Rattle
Release Buttons
Rear Frame
Tubing
DETAIL "B"
Anti-Tipper
Length
Invacare® 9000 Series Wheelchair