Invacare Tracer SX5 User Manual page 56

10 ANTI-TIPPERS/WHEEL LOCKS
Adjusting the Anti-Tippers
 1
A 1 / to 2 inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all
2
times.
1. Place the wheelchair on a flat surface.
 If adjusting anti-tippers on recliner models, ensure
back canes are in the upright position before
making adjustments.
2. Press the release buttons on the wheeled portion of the anti-tipper
and slide it up or down to the desired adjustment hole.
3. Check to make sure that the release buttons are fully engaged in
adjustment holes.
4. Ensure both anti-tippers are adjusted to the same height.
5. Measure the distance between the bottom of the anti-tipper wheels
and the ground/floor.
6. If the distance between the bottom of anti-tipper wheels and the ground/floor is not 1
to 2 inches.
1
7. If the 1 / to 2 inch distance cannot be achieved, a different model may be required. Contact an Invacare dealer or qualified technician.
2
® ®
Invacare Tracer SX5 Wheelchair
FIGURE 2
1
/ to 2 inches, repeat steps 2-5 until the distance is 1
2
56
Release Buttons
1
1 / to 2 inch Clearance
2
Adjusting the Anti-Tippers
Part No. 1110550
1
/
2