Invacare Tracer SX5 User Manual page 55

Installing Anti-Tippers
To ensure the correct model anti-tipper is used refer to chart below. Measurements for anti-tippers are approximate and

are taken with extension tube in bottom hole position.
MODEL SEAT-TO-FLOOR
HEIGHT
1
17 / to 19
2
SX5
1
15 / to 17
2
SX5
1
17 / to 19
RECLINER
2
1. Press the release buttons and insert the anti-tippers with the
anti-tipper wheels pointing toward the ground/floor into the
wheelchair frame tubing.
2. Ensure that the release button of the anti-tipper fully protrudes out
of the hole in the bottom of the wheelchair frame tubing.
3. Place the wheelchair on a flat surface.
4. Measure the distance between the bottom of the anti-tipper wheels
and the ground/floor.

1
A 1 / to 2 inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all
2
times.
5. If the distance between the bottom of anti-tipper wheels and the ground/floor is not 1
Anti-Tippers on page 56.
Part No. 1110550
ANTI-TIPPER (MEASUREMENTS IN INCHES)
LENGTH
1 1
/ inches 13 /
2 2
1 5
/ inches 11 /
2 8
1 1
/ inches 13 /
2 2
HEIGHT MODEL PART NO.
1
3 /
1360
2
3
2 /
1360A
4
1
3 /
N/A
2
Anti-Tipper
Wheels
55
10 ANTI-TIPPERS/WHEEL LOCKS
Anti-Tipper Height
1058836
1058752
Flat Surface
1088242
Anti-Tipper
Release Buttons
Rear Frame Tubing
FIGURE 1 Installing Anti-Tippers
1
/ to 2 inches, adjust anti-tippers. Refer to Adjusting the
2
®
Invacare
Bottom
Position
Anti-Tipper
Length
Anti-Rattle
®
Tracer SX5 Wheelchair