Lenovo S310 Hardware Maintenance Manual page 69

Diagnostic Error Code
014-199-XXX Parallel port test failed, cause unknown
014-2XX-XXX 014-3XX-XXX Parallel port failure
015-000-XXX USB port Interface Test Passed
015-001-XXX USB port Presence
015-002-XXX USB port Timeout
015-015-XXX USB port External Loopback failure
015-027-XXX USB port Configuration/Setup error
015-032-XXX USB port Device Controller failure
015-034-XXX USB port buffer allocation failure
015-035-XXX USB port Reset condition detected
015-036-XXX USB port Register error
015-040-XXX USB port IRQ failure
015-195-XXX USB port Test aborted by user
015-196-XXX USB port test halt, error threshold exceeded
015-197-XXX USB port test warning
FRU/Action
1. Go to "Undetermined problems" on page 76.
2. Flash the system and re-test. See "Flash update
procedures" on page 127.
3. Replace component under function test.
1. External parallel device
2. System board
No action
1. Remove USB device(s) and re-test.
2. System board
1. Remove USB device(s) and re-test.
2. System board
1. Remove USB device(s) and re-test.
2. System board
1. Flash the system. See "Flash update procedures"
on page 127.
2. System board
System board
1. Reboot the system
2. Flash the system and re-test. See "Flash update
procedures" on page 127.
3. Run memory test.
4. System board
1. Remove USB device(s) and re-test.
2. System board
System board
1. Run the Setup Utility program and check for
conflicts.
2. Flash the system. See "Flash update procedures"
on page 127.
3. System board
Information only Restart the test, if necessary.
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility program" on page 51.
2. Re-run test.
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
Chapter 7
.
Symptom-to-FRU Index
63