Lenovo S310 Hardware Maintenance Manual page 63

Diagnostic Error Code
000-198-XXX BIOS test aborted
000-199-XXX BIOS test failed, cause unknown
000-250-XXX BIOS APM failure
000-270-XXX BIOS ACPI failure
001-000-XXX System Test Passed
001-00X-XXX System Error
001-01X-XXX System Error
001-024-XXX System Addressing test failure
001-025-XXX System Checksum Value error
001-026-XXX System FLASH data error
001-027-XXX System Configuration/Setup error
001-032-XXX System Device Controller failure
001-034-XXX System Device Buffer Allocation failure
001-035-XXX System Device Reset condition detected
001-036-XXX System Register error
001-038-XXX System Extension failure
001-039-XXX System DMI data structure error
001-040-XXX System IRQ failure
FRU/Action
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility program" on page 51.
2. Flash the system and retest. See "Flash update
procedures" on page 127.
3. Go to "Undetermined problems" on page 76.
1. Go to "Undetermined problems" on page 76.
2. Flash the system and re-test.
3. Replace component under function test.
1. Flash the system. See "Flash update procedures"
on page 127.
2. System board
1. Flash the system. See "Flash update procedures"
on page 127.
2. System board
No action
System board
System board
System board
1. Flash the system. See "Flash update procedures"
on page 127.
2. System board
1. Flash the system. See "Flash update procedures"
on page 127.
2. System board
1. Run the Setup Utility program.
2. Flash the system. See "Flash update procedures"
on page 127.
3. System board
System board
1. Reboot the system.
2. Flash the system. See "Flash update procedures"
on page 127.
3. Run memory test.
4. System board
System board
System board
1. Adapter card
2. System board
1. Flash the system. See "Flash update procedures"
on page 127.
2. System board
1. Power-off/on system and re-test.
2. System board
Chapter 7
.
Symptom-to-FRU Index
57