HP NetServer AA 4000 Release Note page 22

HP NetServer AA Solution Release Notes
It is very important that you use the correct version of MTCFLASH to update the MICs.
You may need to use a different version of MTCFLASH than that on the MTC diskette
you created from the HP NetServer AA Solution CD, according to the instructions in
Chapter 7 of the
Step 10 on page 18
Step Action
10 Insert the MTC diskette in the floppy drive,
and restart the IOP.
• In the HP NetServer AA Solution Installation
Hardware. Two steps in the section
Delete Steps 12 and 13 from
• In the HP NetServer AA Solution Installation Guide
"Windows NT Installation Guidelines for the HP NetServer AA Solution CE" contains the
following statement which includes an error:
HP NetServer AA Solution CEs must run multiprocessor Windows NT software even
if the CE is a uniprocessor computer.
Do not interpret this statement to mean that uniprocessor CEs are permitted in an HP
NetServer AA Solution Release 3.0 or 3.0 Service Pack 1 server. Multiprocessor CEs are
required in Release 3.0 and 3.0 Service Pack 1. Otherwise, the server will not boot.
• In the HP NetServer AA Solution Installation
The Note in Step 6 should state: Select only the IOP software option.
• In the HP NetServer AA Solution Installation Guide
18
HP NetServer AA Solution Administrator's
with the following:
Installing the Adapters in the CEs
page
Notes
Warning: Make sure that the version of
MTCFLASH you use coincides with
your hotfix level. If you have a hotfix
that supersedes what is contained on the
MTC diskette you created, use the hotfix
diskette to flash the MICs. In that case,
do not use the MTC diskette you created
from the
Solution
Guide, there is an error in
21.
on page
Guide, there is an error in Step 6 on
on page
Guide. Therefore, replace
HP NetServer AA
CD.
Chapter 2,
should be deleted.
31, the table describing
page
58, in the section Completing
52.