Rebooting To The Hp-Ux Prompt - HP Disk Carrier Blade for bh3710 Installation Manual

Rebooting to the HP-UX Prompt

HP-UX can be restarted as shown in the following steps:
Step 1. Telnet to the MP IP.
Step 2. Log in to the MP using the assigned login name and password.
Step 3. Press then type Ecf ("Ecf " is case-sensitive. Capitalize the E, only) and press
Enter
access.
Step 4. When the MP prompt appears, type rs to reset the server and start a system reboot.
Do not use the reset command (rs) while the HP-UX Operating System is running. Use the rs
CAUTION
command only after an orderly operating system shutdown has been accomplished with the
/etc/shutdown -h entry or if the server blade will not respond to console commands. Failure
to observe this precaution may cause file system corruption.
Chapter 5
hp Carrier Grade Server bh3710 Server Blade Installation Information
bp2200 Server Blade
for write
Enter
5-13