Qlogic SANbox2-64 User Manual page 136
Switch management
Hide thumbs
Also See for SANbox2-64:
- Supplementary manual (2 pages) ,
- Brochure (2 pages) ,
- Supplementary manual (2 pages)
Table of Contents
Advertisement
A – Command Line Interface
Set Config Command
The following is an example of the Set Config Port command:
SANbox2-64 N108 #> admin start
SANbox2-64 N108 (admin) #> config edit
SANbox2-64 N108 (admin-config) #>> set config port 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Port Number:
------------------------
AdminState
LinkSpeed
PortType
TLPortMode
ISLSecurity
SymPortName
ALFairness
ARB_FF
InteropCredit (decimal value, 0-255)
ExtCredit
FANEnable
LCFEnable
MFSEnable
MFS_TOV
MSEnable
NoClose
I/O Stream Guard -
VIEnable
CheckAlps
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
A-32
1
(1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online]
(1=1Gb/s, 2=2Gb/s, 3=Auto)
(TL / GL / G / F / FL / Donor)
(1=TLTargetMode, 2=TLInitiatorMode)
(Any /
Ours / None)
(string, max=32 chars)
(True / False)
(True / False)
(decimal value, 0-65535)
(True / False)
(True / False)
(True / False)
(decimal value, 10-20480 msec)
(True / False)
(True / False)
(Suppress RSCN)(Enable / Disable)
(True / False)
(True / False)
[Auto
]
[GL
]
[TLInitiatorMode]
[Any
]
[Port2 ]
[False ]
[False ]
[0
]
[0
]
[True
]
[False ]
[False ]
[640
]
[True
]
[False ]
[Disable]
[False ]
[False ]
59048-01 A
Advertisement
Table of Contents
