Beta Evo 2T 2011 Owner's Manual page 31

4
GB
ADJUSTMENT OF BRAKES ADJUSTMENT OF BRAKES ADJUSTMENT OF BRAKES
ADJUSTMENT OF BRAKES ADJUSTMENT OF BRAKES
F F F F F ront brake ront brake ront brake
ront brake ront brake
The front brake is disk type with hydraulic
control, and therefore requires only ordi-
nary maintenance. If you want to adjust
the position of the lever, use register A A A A A .
R R R R R ear brake ear brake ear brake ear brake
ear brake
The rear brake is disk type with hydraulic
control. You may adjust pedal height by
means of registers B B B B B and C C C C C .
A minimum
reccommended.
ADJUSTMENT OF CL ADJUSTMENT OF CLUT ADJUSTMENT OF CL ADJUSTMENT OF CL ADJUSTMENT OF CL
Only operation that is performed on the
clutch is adjustment of the position of lever
E E E E E . . . . . To do this, use register D D D D D . . . . .
Note: Note: Note: Note: Note:
The device you pressure plate must have a
play between 0.4 mm and 0.6 mm. There-
fore, proceed as follows when replacing
disks:
•Reassemble the clutch without the outer
cover
•Send the control rod to end of travel by
pushing the pressure plate and measure
distance F F F F F
•Operate the clutch lever until the control
rod activates the pressure plate. Measure
distance G G G G G and check that there is
difference of approximately 0.4-0.6mm.
68
of clearance
UTCH UT UT UT CH CH CH CH
is