Front Brake - Beta EVO 2T Instruction Manual

3
GB

FRONT BRAKE

FRONT BRAKE
FRONT BRAKE FRONT BRAKE FRONT BRAKE
Check Check
Check Check Check
To check the front brake wear, simply ob-
serve the caliper from the front, where it is
possible to see the ends of the two pads.
These pads should have at Ieast a 2 mm
Iayer of Iining. If this layer is thinner than 2
mm, replace the pads immediately.
Note: Note: Note:
Note: Note:
Observe the times given on the chart on
pag. 66 when performing the check.
Replacement Replacement
Replacement Replacement Replacement
To replace the pads, proceed as follows:
•Disassemble the disk cover and the
caliper by unscrewing the two screws A A A A A
and loosening the screw B B B B B
•Take off the split pin C C C C C
•Unscrew the screw B B B B B
•Remove the pads D D D D D and replace them
•To reassemble, proceed in the reverse or-
der. Apply medium thread-locking
(frenafiletti medio) to the screws A A A A A
Note: Note: Note:
Note: Note:
To avoid braking problems, pay particular
attention to the correct reassembly of the
split pins.
If the brake disk is removed, ap- If the brake disk is removed, ap- If the brake disk is removed, ap- If the brake disk is removed, ap- If the brake disk is removed, ap-
ply medium thread-locking ply medium thread-locking
ply medium thread-locking to the ply medium thread-locking ply medium thread-locking
screws when reassembling. screws when reassembling. screws when reassembling.
screws when reassembling. screws when reassembling.
60
to the to the
to the to the