Button Setup - Toshiba PC-DKT User Manual

—————————————————————————————————
If you choose Multimedia, you must connect the multi-media cable (supplied in
the pack) to the line-in, line-out connection on the sound card.
Alpha tagged Central Office lines... – these (CO) lines have been given a name
in system programming for identification purposes. You can add, edit, or delete
up to 200 CO lines (see your System Administrator for details).
Miscellaneous – Dial 9 (default to access an outside line) - change as required;
make the PC-DKT a 10 or 20-button phone; check the Handset Cradle Present box
if using a cradle; pop VM access panel on MSG; and set the number of calls you
wish to log (default is 100).
Forward on exit – enables you to forward all your incoming calls to the extension
of your choice (default is No Forward on exit).
This feature must be activated if there is no backup telephone.
Note
4. When you are satisfied with your settings, click OK.

Button Setup

Before using the PC-DKT you must program the buttons that emulate the flexible
buttons on a 20-button DKT. These buttons may be either line or feature buttons,
depending on your system programming. The flexible buttons are programmed within
the telephone system, therefore, you must define the buttons to the PC-DKT.
1. Click Setup, then Button Setup. A
dialog box displays (shown at right).
2. Under Flexible Key, highlight a line
button from the list; change its Key
Type to one of the following:
[PDN] Key (up to four [PDNs] can
be selected)
External Key (CO line button or
Pooled Line Group button)
Speed Dial Select (SDS) button
None of the Above (non-line buttons; e.g., [SDNs], [PhDNs], DSS, Call
Forwarding, DND). See your system administrator for more details on this button.
Installation
Step 5: Set System Parameters
2136
17