Spin Welder User's Manual
palm switches activate the spin welder, the display
also indicates
in green. These indicators
IN CYCLE
are shown in Figure 6–4.
Pneumatic Controls
Air Pressure Regulator
The air pressure regulator is located on the front
panel of the Spin Welder and is shown in Figure 6–5.
The pressure regulator knob is a ten–turn control.
About five turns are required to change the setting
from 0 to 100 psi (6.9 bar). Turning the knob clock-
wise increases the pressure.
Pressure
Gauge
Pressure
Regulator
Lock
Ring
Downspeed
Adjustment
Figure 6–5 Front Panel Controls, Display and Gauge
Regulator Gauge
The applied air pressure is indicated on the regulator
gauge located directly above the regulator control
knob. The gauge has a 1.5" diameter dial with a
2
range of 0 to 100 psi (0 to 7 kg/cm
) and is shown
in Figure 6–5.
Dukane Manual Part Number 403-547-03
Page 40