Table of Contents
Advertisement
4 inverter connector
Replacing the Display Panel
1. Reconnect the top display-cable connector to the top flex-cable connector.
2. Reconnect the bottom flex-cable connector to the inverter connector.
3. Replace the display panel inside the display back cover.
NOTE:
The eight screw locations are numbered. Replace the screws in sequential order.
4. Replace the eight M2 x 3-mm screws (four on each side) in order around the display panel.
5. Replace the display bezel (see
Display Latch
Removing the Display Latch
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE:
To help prevent damage to the system board, you must remove the main battery (see
begin working inside the computer.
1. Follow the instructions in
Before Working Inside Your
2. Remove the display assembly (see
3. Remove the display bezel (see
4. Slide the latch to the right and gently lift.
5. Remove the spring that attaches the latch to the display panel.
1
spring
Replacing the Display Latch
Replacing the Display
Bezel).
Computer.
Removing the Display
Assembly).
Removing the Display
Bezel).
2
display latch
Before Working Inside Your
Computer) before you
Hide quick links:
Advertisement
Table of Contents
