Table of Contents
Advertisement
Display Panel
Removing the Display Panel
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE:
To help prevent damage to the system board, you must remove the main battery (see
begin working inside the computer.
1. Follow the instructions in
Before Working Inside Your
2. Remove the display assembly (see
3. Remove the display bezel (see
4. Remove the eight M2 x 3-mm screws (four on each side of the display panel).
5. Lift the display panel out of the display back cover.
1 display panel
4 grounding wire and captive screw
6. Press in both sides of the top flex-cable connector, and pull the top flex-cable connector away from the display connector.
7. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.
1 pull-tab on bottom flex-cable
connector
Computer.
Removing the Display
Assembly).
Removing the Display
Bezel).
2 M2 x 3-mm screws (8)
3 display back cover
2 top flex-cable
3 display cable
connector
Before Working Inside Your
connector
Computer) before you
Hide quick links:
Advertisement
Table of Contents
