Table of Contents
Advertisement
THE FUNCTION OF CONTROL PANEL
Press this switch to turn the power 'ON' or 'OFF'.
Operation and temporary stop is repeated as it is pressed. When you want to change program in
operating; Press the 'Start/Pause' button
'Start/Pause' button again.
You can select the course you want and each lamp is turned on when that course is selected.
You can select the wash course you want and each lamp is turned on when that course is selected.
As this button is pressed, the wash course is selected by 'Quick Wash'(proper load amount :1~2kg)
'Small'(proper load amount :2~3kg)
You can select the rinse time(s) you want and each lamp is turned on when that course is selected.
As this button is pressed, the rinse time(s) is selected by '1'
... ...
You can select the spin speed you want and each lamp is turned on when that course is selected.
It can be used to pre-engage time for wash from 1 hr to 12 hrs.
It can be used to adjust water temperature according to types of the load to be washed.
As this button is pressed, water temperature is selected by Cold
You can select the dry condition you want and each lamp is turned on when that course is selected.
Use this function when you want to protect any accident occurring from handling of washer by a child. During
an operation of washer, press 'TEMP' and 'DRY' buttons simultaneously during 3 second.
If this mode will be set successfully, CHL and remain time will be showen on PCB board alternately.
In Child Lock mode, no button functions except Power button.
If you want to set this mode, press 'TEMP' and 'DRY' buttons simultaneously during 3 second.
And if you want to release this mode, press 'TEMP' and 'DRY' buttons simultaneously again during 3 second.
If you want to change to the desire program, while this mode is working;
1. Press 'TEMP' and 'DRY' buttons simultaneously again during 3 second.
2. Press the 'Start/Pause' button.
3. Select the desired program and press the
* The Child Lock will be cancelled when power is off.
If you want to open Door intensionally during operation, press the 'Start/Pause' button and press again
'Door unlock' button. In this case,
after cooling insideTub temperature and draining water, also no button functions except Power button.
You can select the amount of steam and each lamp is turned on when the course is selected
Use the curtail the full cycle time to about 10 min.
After you select the course and press the 'TIME SAVE' button, then the'TIME SAVE' light will be turned on.
If you select the 'Drum Drying' or 'Quick 30' course, the 'Time Save' will net be selected
'5'
'Rinse Hold'
'1'.
'Start/Pause' buttom again.
signal will be appeared on PCB board, then you can open Door
9
(C-ED1243NPX)
Select the program that you want to change
'Main Wash'
'Pre Wash'
'Soak'
'Rinse Hold'
30°C
Press the
'Quick Wash' .
'2'
'Rinse Hold'
40°C
60°C
95°C.
Change
the desired
program
Advertisement
Table of Contents
