Using The Warming Drawer; Moisture Selector - GE Monogram ZKD910 Owner's Manual

Control
The warming drawer controls are hidden with
knob the drawer shut. Open the drawer. The controls
are on the right side of the front frame.
To use the warming drawer, press the ON/OFF
switch to the ON position.
Slide the moisture selector control to the open
or closed setting. (See the Moisture Selector
section.)
Turn the control knob clockwise to the desired
setting.
ON signal
The ON signal light is located below the
ON/OFF switch and glows when the ON/OFF
light
switch is in the ON position. It stays on until the
ON/OFF switch is moved to the OFF position.
Moisture
The moisture selector is located on the inside
front of the drawer.
selector
To keep foods moist, slide the moisture selector
control away from the control knob. This closes
the vent and seals the moisture inside the
drawer. With the vent closed hot foods stay
moist and soft.
In this setting condensation may occur around
the inside edge of the drawer.
To keep foods crisp, slide the moisture selector
control to the right towards the control knob.
This opens the vents and allows the moisture
to escape.
With the vents open, it is normal for moisture to
collect on surfaces above the warming drawer.
Additional
An accessory pan kit JXPN2 is available from
GE at extra cost.
pans
Two pans with lids (4" deep)
• One large pan (14 quarts)
• One medium pan (6 quarts)
PROOF . . . 75–95°F. MED . . . . . 160–195°F.
LOW . . . . . 140–160°F. HIGH . . . . 195–230°F.

Using the Warming Drawer

Electric Warming Drawer
PROOF
HI
The ON signal light is visible through the light
viewer in the drawer front panel when the
drawer is closed. This is a reminder that the
heat is on.
LO
MED
7