Canon imageCLASS D780 Fax Manual page 81

3.AUTO REDIAL
ON
OFF
1.REDIAL TIMES
2.REDIAL INTERVAL
3.TX ERROR RESEND
4.ERASE FAILED TX
ON
OFF
5.TIME OUT
ON
OFF
RX SETTINGS
1.ECM RX
ON
OFF
2.FAX/TEL OPT.SET
1.RING START TIME
2.F/T RING TIME
3.F/T SWITCH ACTION
RECEIVE
DISCONNECT
9-6
Name
ON
OFF
Descriptions
Sets whether to perform automatic redial when the other
line is busy or no answer.
Customizes the redial operation.
After the first attempt at dialing fails, redialing is not
attempted.
Sets the number of retries.
1 to 10 TIMES (2 TIMES)
Sets period of time between redialings.
2 to 99 MIN. (2 MIN.)
Redialing is attempted when a transmission error occurred.
RESEND TX FROM: Sets the number of pages to be sent
when redialing is attempted.
ERROR & 1ST PAGE, ERROR PAGE, ALL PAGES
Redialing is not attempted when a transmission error has
occurred.
Sets the ERASE FAILED TX function.
The document is deleted from the memory stored in the
machine if a transmission error has occurred.
The document is not deleted from the memory stored in
the machine even if a transmission error has occurred.
Enables/disables automatic scanning of documents after
the fax number is entered by using speed dialing.
Scanning begins automatically in 5 or 10 seconds after
you enter the phone number.
Press Start to scan document. Otherwise, the machine
will return to standby mode after 2 minutes while the
AUTO CLEAR function activates.
Sets the reception functions.
ECM (error correction mode) receiving is turned on or off.
All receptions are conducted with ECM if the other
party's fax supports ECM.
ECM is turned off.
When FaxTel has been set, the optional settings are
available.
Sets the duration that the machine listens for a fax tone
before starting to ring.
0 to 30 SEC (8 SEC)
Sets the length of time the machine rings to alert you of
an incoming call.
15 to 300 SEC (15 SEC)
Selects the action taken after the F/T RING TIME
expires.
The machine switches to fax receive mode automatically
at that point and starts to receive the document.
The machine disconnects the call.
(The factory default setting is in bold face.)