Yamaha Tmix XP500Y Owner's Manual page 60

PERIODIC MAINTENANCE AND ADJUSTMENT
2
1
1
2
3
1. Oil filter wrench
2. Oil filter cartridge
4
TIP
5
An oil filter wrench is available at a
Yamaha dealer.
6
7. Apply a thin coat of clean engine
oil to the O-ring of the new oil filter
7 cartridge.
TIP
Make sure that the O-ring is properly
8
seated.
9
8. Install the new oil filter cartridge,
and then tighten it to the specified
torque with a torque wrench.
1
1. Torque wrench
Tightening torque:
Oil filter cartridge:
17 Nm (1.7 m·kgf, 12.3 ft·lbf)
9. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
Tightening torque:
Engine oil drain bolt:
43 Nm (4.3 m·kgf, 31.1 ft·lbf)
10. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
7-14
Recommended engine oil:
See page 9-1.
Oil quantity:
Without oil filter cartridge replace-
ment:
2.80 L (2.96 US qt, 2.46 Imp.qt)
With oil filter cartridge replacement:
2.90 L (3.07 US qt, 2.55 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
G
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G
Make sure that no foreign mate-
rial enters the crankcase.
ECA11620