Yamaha Tmix XP500Y Owner's Manual page 26

INSTRUMENT AND CONTROL FUNCTIONS
oil change indicator "OIL" flashes (i.e.
before the periodic oil change interval
has been reached), the indicator "OIL"
must be reset after the oil change for
1 the next periodic oil change to be indi-
cated at the correct time.
The electrical circuit of the indicator can
2
be checked according to the following
procedure.
3
1. Set the engine stop switch to "
and turn the key to "ON".
2. Check that the oil change indicator
4
comes on for a few seconds and
then goes off.
5
3. If the oil change indicator does not
come on, have a Yamaha dealer
6
check the electrical circuit.
7
8
9
V-belt replacement indicator
"V-BELT"
"
1. V-belt replacement indicator "V-BELT"
This indicator flashes every 20000 km
(12500 mi) when the V-belt needs to be
replaced.
After changing the V-belt, reset the
V-belt replacement indicator. To reset
the V-belt replacement indicator, select
it by pushing the "SELECT" button until
"V-BELT Trip" is displayed, and then
push the "RESET" button at least 1 sec-
ond. When pushing the "RESET" but-
ton, "V-BELT Trip" starts flashing.
While "V-BELT Trip" is flashing, push
the "RESET" button for at least 3 sec-
onds.
If the V-belt is changed before the
4-7
V-belt replacement indicator "V-BELT"
flashes (i.e. before the periodic V-belt
change interval has been reached), the
1
indicator "V-BELT" must be reset after
the V-belt change for the next periodic
V-belt change to be indicated at the
correct time.
The electrical circuit of the indicator can
be checked according to the following
procedure.
1. Turn the key to "ON" and make
sure that the engine stop switch is
set to "
2. If the V-belt replacement indicator
does not come on, have a Yamaha
dealer check the electrical circuit.
Self-diagnosis device
1
1. Error code display
".