Water Temperature; Rinse Agent; Detergents; Using The Dishwasher - GE Monogram ZBD6400 Owner's Manual

Water
Temperature
Use a Rinse
Agent
Use only detergent specifically made for use

Detergents

in dishwashers. Keep your powdered detergent
fresh and dry. Don't put powder detergent into
the dispenser until you're ready to wash dishes.
The amount of detergent to use depends on
whether your water is hard or soft. With hard
water, you need extra detergent. With soft
water, you need less detergent.
Protect your dishes and dishwasher by
contacting your water department and asking
how hard your water is. Twelve or more grains
is extremely hard water. A water softener is
recommended. Without it, lime can build up
in the water valve, which could stick while open
and cause flooding. Too much detergent with
soft water can cause a permanent cloudiness of
glassware, called etching.
To open the detergent compartment, push the
lever latch inward.
The entering water must be at least 120°F
(49°C) and not more than 150°F (66°C), for
effective cleaning and to prevent dish damage.
Check the water temperature with a candy or
meat thermometer. Turn on the hot water faucet
A rinse agent improves dry performance,
reduces spots and prevents new film build-up
on your dishes, glasses, flatware, cookware
and plastic.
Fill the rinse agent chamber by rotating the
round cap counterclockwise and remove. Fill
chamber to maximum level. Replace and lock
the cap into place.
To check if rinse agent is needed: a solid black
indicator indicates sufficient rinse agent; a clear
indicator indicates a low level and requires
adding more rinse agent.
•A full dispenser should last about one month.

Using the dishwasher

Dishwasher
nearest the dishwasher, place the thermometer
in a glass and let the water run continuously into
the glass until the temperature stops rising.
•If rinse agent spills, wipe it up immediately.
It can keep your detergent from working.
•If after washing you notice cloudy spots,
streaks or water marks on the glassware, and
the rinse agent dispenser is not empty, it may
be necessary to increase the dispenser settings.
To do so, remove the cap and using a butter
knife, rotate the indicator arrow to a higher
number. Replace the cap when done.
•If glasses appear smeared or there is foam
present on the bottom of the glasses or the
bottom of the machine, select a lower dosage
number.
•For softened water, reduce dispenser setting.
Adjust to higher or lower number
When using automatic dishwashing detergent
tabs, place one tab in the main cup and close.
Be sure the Cycle Status Indicators (on some
models) are not lit before adding detergent.
Otherwise, the detergent cup will not close and
latch properly. Add detergent then close the
main cup.
NOTE: To open detergent cup after it has been
closed, push the lever latch inward.
Light level Indicator
Main compartment
Auxiliary
compartment
Lever
17