Table of Contents
Advertisement
Millennium 4 Mnl M4090
PROGRAMMING AUDIO CONTROL
Using the Millennium 4's Audio mode, you can also con-
trol an audio component, such as CD or DVD player, a
stereo receiver, a stereo amplifier, or a DBS audio service.
Locate the brand name of your audio component in the
one of accompanying code lists (starting on the next
page).Write it in the appropriate space.
CD Player Brand: ____________________________
or
DVD Player Brand: ____________________________
or
Stereo Receiver Brand: __________________________
or
Stereo Amplifier Brand: ________________________
or
DBS Audio Brand: ____________________________
The brands are listed in alphabetical order with popular
codes listed first.You will use one of these codes to pro-
gram the Millennium 4 to operate your audio component:
1.
Turn on the audio component (or DBS receiver
to control its audio service).
2.
On the Millennium 4, press AUDIO once. Press
and hold SETUP until the LED blinks twice,
then release SETUP.
3.
Enter the first four-digit code for your audio
component. If you perform this procedure cor-
rectly, the LED will blink twice.
NOTE: If the LED did not blink twice after entering
the code's last digit, then repeat steps 2 through 3 and
try entering the same code again.
4.
Aim the Millennium 4 at your audio compo-
nent and press POWER once. The unit should
turn off. If it does not respond, repeat steps 2-3,
trying each code listed for your brand until you
find one that works. If it still does not work , try
searching for the code (see Searching For Your
Code on page 26).
5.
Write your audio component code in the boxes
below for future reference.
22
7/23/99 9:34 AM
Page 22
Advertisement
Table of Contents
