Programming The Tune-In Keys; To Program A Tune-In Key; To Clear A Tune-In Key - Universal Electronics Millenium 4 User Manual

Millennium 4 Mnl M4090
PROGRAMMING THE TUNE-IN KEYS FOR
SPECIFIC CHANNELS
The Millennium 4 includes three "Tune-In" keys (located
directly below the PAGE keys). Each can be programmed
to remember three of your favorite channel settings for a
total of nine channels. If you want to change the channels
in a previously-programmed "Tune-In" key, you'll need to
clear the key first (see below).
To program a "Tune-In" key:
1. On the Millennium 4, press and hold SETUP
until the LED blinks twice, then release SETUP.
2. Enter 9 - 9 - 5. The LED will blink twice. Then
select a "Tune-In" key and press it once.
Press CBL once followed by the channel num-
3.
ber to be programmed (e.g., 3 - 9).
NOTE: If you are programming a channel for a
Digital Cable Converter, you need to enter all chan-
nels in a 3-digit channel format. For example, if the
desired channel is 39, then enter it as 0 - 3 - 9 .
4. Press and hold SETUP until the LED blinks
twice, then release SETUP.
5. To add another channel, repeat steps 1-4 sub-
stituting the new channel to be added in step 3.
NOTE: Programming more than three channels onto
the same "Tune-In"key will overwrite previous settings.
To clear a "Tune-In" key:
1. On the Millennium 4, press and hold SETUP
until the LED blinks twice, then release SETUP.
2. Enter 9 - 9 - 5. The LED will blink twice. Then
select a "Tune-In" key you want cleared and
press it once.
Press and hold SETUP until the LED blinks
3.
twice, then release SETUP.
4. This "Tune-In" key is now clear and ready for
reprogramming (see above – Programming
The Tune-In Keys For Specific Channels).
5. If desired, repeat steps 1 though 4 to clear
another "Tune-In" key.
29
7/23/99 9:34 AM Page 29