Table 1: Front Panel Sp-10D Digital Video Processor - Kramer SP-10D User Manual

Table 1: Front Panel SP-10D Digital Video Processor

# Feature
1 POWER Switch
2 INPUT STANDARD LEDs
3 INPUT Selector Button
4 INPUT LEDs
5 AUTO Button
6 OUTPUT STANDARD LEDs
7 (COMPONENT) OUTPUT
Button
8 COMPONENT OUTPUT LEDs Cycle between YUV, RGB, and RGBS. The corresponding LED
9 STANDARDS Button
10 SCH Button
11 GENLOCK Button
12 SPLITTER Button
13 DELAY Button
14 V-SHARP Button
15 H-SHARP Button
16 BRIGHTNESS Button
17 CONTRAST Button
18 H-SHIFT Button
19 V-SHIFT Button
20 GAIN Button
21 Y/GREEN Button
22 COLOR Button
23 U/BLUE Button
1 Data delay problems, especially with long cables, occur when electronic signals travel via coaxial cable and the picture
shifts mainly in the horizontal axis (due to unequal delays between the sync signals and data). Center the picture by pressing
the DELAY button and adjust via the + and – buttons
2 To add brightness
3 To fade the picture in and out
4 For YUV
5 For RGB
6 When the COLOR SPACE button is selected
7 Pressing the + button enhances dull colors. Pressing the – button reduces distortion (snow)
6
Your SP-10D Digital Video Processor
Illuminated switch for turning the unit ON or OFF
Cycle between PAL B, PAL N, PAL M, NTSC 3, NTSC 4, and
SECAM. The corresponding LED lights
Press to select the source, illuminating the appropriate LED
Cycle between the video sources: CV, YC, YUV, and RGB/S. The
corresponding LED lights
Toggles between automatically recognizing the input standard
(lighting the appropriate LED) and the manual selection mode
Cycle between PAL B, PAL N, PAL M, NTSC 3, NTSC 4, and
SECAM. The corresponding LED lights
Selects the component video output signal
lights
Selects the output video standard
Press the SCH button and adjust the subcarrier to horizontal
phase relative to the genlock source, using the + and – buttons
Press to enable GENLOCK operation
Press the SPLITTER button and adjust the position of the
boundary between the edited image and the original image, using
the + and – buttons
Press the DELAY
signal relative to the genlock source, using the + and – buttons
Press the V-SHARP button and adjust the vertical sharpness
using the + and – buttons
Press the H-SHARP button and adjust the horizontal sharpness
using the + and – buttons
Press the BRIGHT button and adjust using the + and – buttons
Press the CONTRAST button and adjust using the + and – buttons
Press the H-SHIFT button and adjust H-Chroma-Luma delay using
the + and – buttons to enable horizontal shifting of the image
Press the V-SHIFT button and adjust V-Chroma-Luma delay using
the + and – buttons to enable vertical shifting of the image
Press the VIDEO GAIN button and adjust using the +
4
Press the Y /GREEN
buttons
Press the COLOR
4
Press the U /BLUE
Function
1
button and adjust the H-delay of the output
5 6
button and adjust using the + and –
7
button and adjust using the + and – buttons
5 6
button and adjust using the + and – buttons
KRAMER: SIMPLE CREATIVE TECHNOLOGY
2 3
and – buttons