Table of Contents
Advertisement
Chapter 2
Camera Installation
Rotate the IP camera to adjust the horizontal orientation until you achieve a level image.
c.
(Optional) If the IP camera is installed in a high humidity environment, remove the wrapper from the
Step 10
included silica gel pack and place the pack with the camera inside the VR housing. Ensure that the silica
gel pack does not obstruct the IP camera field of view.
Attach the dome cover to the camera by aligning it with the mounting holes.
Step 11
Use the included wrench and tighten the four dome cover screws to secure the dome cover to the camera.
Step 12
Make sure all parts of the camera are securely installed.
What to do next
Complete the following procedures:
After you install the IP camera, follow the instructions in the
•
Camera" section on page 3-1
OL-28692-01
Installing the IP Camera with a Vandal Resistant Enclosure
to access the IP camera through your network.
Cisco Video Surveillance 7030 IP Camera Installation Guide
"Performing the Initial Setup of the IP
2-9
Advertisement
Table of Contents
