Powering The Ip Camera On Or Off; Resetting The Ip Camera - Cisco 7030 Installation Manual

Powering the IP Camera On or Off

(Optional) Click Auto Focus to have the IP camera automatically adjust its focus. To automatically
Step 7
adjust the focus to a particular region in the field of view, check the Specify Region check box and draw
or select a region before clicking Auto Focus.
Powering the IP Camera On or Off
The IP camera does not include an on/off switch. You power it on or off by connecting it to or
disconnecting it from a power source. When you power off the IP camera, configuration settings are
retained.
To power on the IP camera, take either of these actions:
•
•
To power off the IP camera, take either of these actions:
•
•

Resetting the IP Camera

You reset the IP camera by pressing the Reset button on the IP Camera (see
There are various reset types, as described in
You also can also perform these reset operations from the Maintenance Settings window as described in
the Cisco Video Surveillance 7000 Series IP Camera Configuration Guide.
Table 4-3
Reset Type
Reboot.
Factory reset.
Cisco Video Surveillance 7030 IP Camera Installation Guide
4-4
Use an STP (shielded twisted pair) Category 5 or higher network cable to connect the IP camera to
a network switch that provides 802.3af compliant PoE.
Use an optional 12 VDC or 24VAC power adapter to connect the IP camera to a wall outlet
If the IP camera is receiving PoE, disconnect the network cable
If the IP camera is receiving power through the power adapter, unplug the adapter from the wall or
disconnect it from the camera
Resetting the IP Camera
Table 4-3.
Procedure
Press and immediately release
the Reset button.
Press and hold the button for at
least 15 seconds.
Chapter 4 Camera Management
Figure 1-1 on page
Remarks
This action is equivalent to
powering the IP camera down
and then powering it up. Settings
that are configured for the IP
camera are retained.
Sets all IP camera options to
their default values. After you
perform this procedure, follow
the steps in the "Performing the
Initial Setup of the IP Camera"
section on page 3-1.
OL-28692-01
1-3).