Table of Contents
Advertisement
Installing the IP Camera with a Vandal Resistant Enclosure
Use the included L-type wrench to secure the conduit base to the mounting plate with the three included
Step 7
screws.
Step 8
(Optional) Use mini cable with BNC connector to temporarily attach an NTSC or PAL compliant analog
video display device to the analog video out port on the rear of the IP camera.
The mini cable with BNC adapter is included in the audio/video cables accessory kit, which you can
Note
purchase from Cisco (Cisco part number CIVS-AVCABLE).
Analog video is enabled by default to allow you to adjust the camera field of view during installation.
However, it is not supported as a normal camera feed and is automatically disabled when any of the
following camera settings are made:
The primary video stream frame rate must be set higher than 15 fps.
•
The secondary video stream must is enabled.
•
We recommend that you disable analog video after installation. To disable analog video, see the Cisco
Note
Video Surveillance 7000 Series IP Camera Configuration Guide.
While viewing video from the IP camera, perform the following steps to adjust the 3-axis field of view:
Step 9
Grip the two tilt adjustment screws and pan the IP camera left or right.
a.
Loosen the two tilt adjustment screws, tilt the IP camera, then tighten the screws.
b.
Cisco Video Surveillance 7030 IP Camera Installation Guide
2-8
Chapter 2
Camera Installation
OL-28692-01
Advertisement
Table of Contents
