Using The Clock And Timer - GE JMP31 Owner's Manual

Using the clock and timer.

Make sure the clock is set to the
correct time of day.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 59
minutes.
14
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
To Set the Timer
Press the KITCHEN TIMER ON/OFF
pad.
Press the INCREASE or DECREASE
pads until the amount of time you
want shows in the display.
If you make a mistake press the
KITCHEN TIMER ON/OFF pad and
begin again.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the KITCHEN TIMER ON/OFF pad, then
press the INCREASE or DECREASE pads
until the time you want appears in the
display.
To Cancel the Timer
Press the KITCHEN TIMER ON/OFF pad
twice.
Power Outage
After a power outage, when power is
restored the display will flash and time
shown will no longer be correct—for
example, after a 5-minute power interruption
the clock will be 5 minutes slow.
Press the CLOCK pad.
Press the INCREASE or DECREASE
pads.
Press the START pad.
Press the START pad.
When the timer reaches :00, the
control will beep 3 times followed by
one beep every 6 seconds until the
KITCHEN TIMER ON/OFF pad is
pressed.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the KITCHEN TIMER ON/OFF pad
and then pressing the INCREASE or
DECREASE pads to enter the new time
you want.
The display flashes until the clock is reset.
All other functions that were in operation
when the power went out will have to be
programmed again.