Cycle Sequence - GE GSD4210 Owner's Manual

Cycle Sequence

Water
Cycles (approx.)
NORMAL WASH 8.4 gal.
POTS PANS 9.9 gal.
SHORT WASH 6.9 gal.
CHINA CRYSTAL 7.7 gal.
Options
2
TEMP BOOST
ENERGY
SAVER
DRY ON
ENERGY
SAVER
DRY OFF
RESET
DELAY START
Start
3
Touch the START pad to begin the cycle. There is a time
delay between start-up and water fill so you will not hear
any wash action right away.
Time
(approx.)
63 min.
63 min.
63 min.
63 min.
Drying Options:
ENERGY SAVER DRY OFF. Available on all wash cycles. Add
approximately 32 minutes to the cycle.
ENERGY SAVER DRY ON. Drying heater is turned off.
Dishes dry naturally.
Provides extra heat for best performance. It is used
best with heavily-soiled dishes.
Shuts off the drying heat options. Dishes air dry
naturally and energy is saved. You can prop the door
open after the word CLEAN appears in the display.
Turns the drying heater on for fast drying. This
cycle will extend the time to your wash cycle.
To change a cycle after washing starts, touch the
RESET pad to cancel cycle. After water is pumped
out and motor stops, you can reprogram and restart
the dishwasher.
You can delay the start of a wash cycle for up to 8
hours. Tap or press and hold the DELAY START pad
to choose the number of hours you want to delay
the start of the cycle. The machine will count down
and start automatically at the correct time. NOTE:
If you forget to latch the door a reminder signal will
beep until you do so.
Cycle Sequence
Rinse Rinse Main Wash Rinse Rinse Rinse
Rinse Rinse Rinse Main Wash Rinse Rinse Rinse
Rinse Rinse Rinse Main Wash Rinse Rinse Rinse
Rinse Rinse Main Wash Rinse Rinse Rinse
9