GE GSD4210 Owner's Manual page 11

Display What It Means
Drain is blocked. This
WASH
indicates that the drain
is so clogged that the
WASH
dishwasher cannot
LIGHT
continue to operate in
FLASHING
a satisfactory manner.
Dishwasher will stop.
Not enough water is
RINSE
entering the dishwasher.
RINSE
LIGHT
FLASHING
Before You Call For Service
Try the cycle again to see if the light flashes again. The
dishwasher may correct itself.
Electronic controls can be affected by outside interference.
Sometimes shutting off power to the dishwasher (at the fuse or
circuit breaker) could correct the problem. Restore power after
15 seconds and try the cycle again.
Check the guide for things you can do to correct the problem.
See the Before you call for service section at the back of this manual.
What To Do
Locate and remove the blockage in
the drain system.
1 Check the air gap (see the Air
Gap section).
2 Check for a kink in the drain hose.
3 Check for stopped-up drains.
( NOTE: Warranty service does not
cover household drain problems.)
To pump any remaining water out of
the machine:
1 Latch door.
2 Touch RESET . Select desired cycles
and then touch START and RESET
again.
Unlatch the door. If there is no water
in the bottom of the dishwasher, check
the water supply to the dishwasher.
Is the dishwasher water supply turned
•
on? (Valve usually located under the
sink.)
Is the household water supply
•
turned on?
If you use well or cistern water, is the
•
supply adequate?
Press the RESET pad. If the water
supply is adequate, try the cycle
again. If the RINSE light flashes
again, call for service.
11