Control Panel Lights - GE GSD4210 Owner's Manual

About the control panel lights.
Display
RESET
RESET
LIGHT
FLASHING
DRY
DRY
LIGHT
FLASHING
10
What It Means
Electrical power to the
dishwasher has been
interrupted but is now
back on.
There is too much water
in the dishwasher.
What To Do
IF DISHWASHER WAS IN USE WHEN
THE POWER FAILURE OCCURRED:
1 Press the RESET pad and wait
approximately 30 seconds.
2 Unlatch and open the door.
A If the detergent cup is open and
empty, close the door and rerun
the cycle with detergent in the
closed cup only.
B If the detergent cup is closed reset
the dishwasher for the wash cycle
you want.
IF THE DISHWASHER WAS NOT IN USE
when power failure occurred, use
dishwasher as you normally would.
The dishwasher is designed to
automatically pump out extra water
as long as the door is latched. When
you hear the motor stop running:
1 Unlatch the door and see if all the
water is gone. (It is normal for a
small amount of water to remain in
the bottom of tub to keep the water
seal lubricated.)
2 If you see water entering the
dishwasher, close and latch the door.
Shut off the water supply to the
dishwasher.
3 Press the RESET pad.
4 If water is gone and no water is
entering the dishwasher, restart
cycle.
5 If the DRY light starts to flash again,
shut off the water supply to the
dishwasher. Call for service.