Ice Cube Solenoid; Evaporator - GE GSS20 Series Technical Service Manual

2. Remove 2 Phillips mounting screws.
3. Pull out the motor.
4. Disconnect the wire connectors.
5. Remove the drive fork and nut.
Solenoid Mounting Screws Solenoid Mounting Screws
6. Disconnect the motor wiring connectors.
7. Remove 3 motor mounting screws.
8. Remove the motor from the housing.

Ice Cube Solenoid

The ice cube solenoid energizes when the cube
mode is selected on the dispenser control panel.
1. Remove the ice dispenser tray and assembly
(see page 21).
2. Remove 2 Phillips mounting screws.
3. Pull out the motor.
4. Disconnect the wire connectors.
5. Remove the ground wire to the ice cube
solenoid.
6. Disconnect the wire connectors.
Motor Motor
Mounting Mounting
Screws Screws
7. Remove 2 solenoid mounting screws.
8. Slide the solenoid out of the housing.
GEA00919

Evaporator

Air is driven across the evaporator coils to
produce cold air for the freezer and fresh food
compartments. Evaporator is replace like previous
models.
1. Complete steps 4 and 5 in the Evaporator
Fan procedure.
Wiring Wiring Wiring
Connectors Connectors Connectors
GEA00892
2. Remove 3 Phillips screws from the evaporator
mounting.
3. Cut the capillary and suction line.
4. Remove the evaporator.
– 26 –
Solenoid Solenoid Solenoid
Motor Motor Motor
Screw Screw
Ground Ground Ground
Wire Wire Wire
GEA00695
GEA00893