GE GSS20WBB - 20.0 cu. Ft. Refrigerator Energy Manual
Energy guide
Hide thumbs
Also See for GSS20WBB - 20.0 cu. Ft. Refrigerator:
- Owner's manual and installation instructions (64 pages) ,
- Dimensions and installation information (2 pages)
Advertisement
U.S. Government
Refrigerator-Freezer
• Automatic Defrost
• Side-Mounted Freezer
• With Through-the-Door Ice
$59
Your cost will depend on your utility rates and use.
Cost range based only on models of similar capacity with automatic defrost,
side-mounted freezer, and through-the-door ice.
Estimated operating cost based on a 2007 national average electricity cost
of 10.65 cents per kWh.
For more information, visit www.ftc.gov/appliances.
Federal law prohibits removal of this label before consumer purchase.
Estimated Yearly Operating Cost
650
Estimated Yearly Electricity Use
Model(s): GSS20IET, GSS20GEW
Capacity: 20.0 Cubic Feet
$
kWh
197D7891P032A
69
$69
Advertisement
Table of Contents
Need help?
Do you have a question about the GSS20WBB - 20.0 cu. Ft. Refrigerator and is the answer not in the manual?
Questions and answers
STOPPED WORKING NOT FREEZING OR COOLING. NO DISPLAY ON PANEL. INSIDE LIGHTS ON
The GE GSS20WBB refrigerator may not be freezing or cooling, with no display on the panel but the inside lights on, due to several possible reasons:
1. Control Board Failure – If the display is off but the lights are on, the main control board may be faulty and not sending power to the cooling system.
2. Temperature Controls Set Incorrectly – If the controls are not set properly, the cooling system may not activate. Check the settings.
3. Door Left Open – If a package or obstruction is holding the door open, it can cause cooling issues.
4. Frequent or Long Door Openings – This can lead to temperature fluctuations and poor cooling performance.
5. Compressor or Start Relay Issue – If the compressor is not running, it could be due to a faulty start relay or a failed compressor.
6. Power Supply Issue – Ensure the refrigerator is properly connected to a working power outlet.
If none of these resolve the issue, a technician may need to inspect the control board, compressor, or other electrical components.
This answer is automatically generated