Ice Dispenser Auger Drive And Cube Solenoid; Icemaker - GE PSC21MGM Technical Service Manual

6. With 2 small flat-blade screwdrivers, unlock
the ice crusher locking tabs located at either
side of the ice crusher.
7. Lift the ice crusher out of the bucket.
8. Remove the ice crusher back cover.
9. Remove the locking ring from the ice crusher
auger.
10. Remove the plastic nut with a pair of pliers by
turning it clockwise.
11. Remove the spacers and blades. The blades
are numbered for reassembly.
Ice Dispenser Auger Drive and Cube
Solenoid
The ice dispenser drive motor and cube solenoid
are located in the upper rear of the freezer
compartment. The drive motor moves the auger
via a fork located on the drive motor. The cube
solenoid allows cube or crushed ice to be
dispensed on demand.
1. Remove 1/4-in. housing mounting screws (4)
located at the four corners of the housing.
2. Slide the housing forward until the connector is
visible, disconnect the connector, and remove
the unit from the housing.
Screws Screws
Note: Drive fork has reverse threads; turn
clockwise to remove.
3. Remove the fork from the drive motor by
turning it clockwise.
4. Disconnect the motor connectors and remove
the ground wire.
5. Remove 1/4-in. mounting screws (3) and
remove the motor.
6. Disconnect the cube solenoid wires.
7. Remove cube solenoid 1/4-in. mounting
screws (2) and remove the cube solenoid.

Icemaker

The icemaker is located in the upper rear of the
freezer compartment and supplies ice to the
dispenser tub.
1. Disconnect the icemaker cable connector.
2. Remove 1/4-in. icemaker mounting screws
and slide out the icemaker.
This refrigerator is equipped with an Electronic
Icemaker. Refer to Pub # 31-9063 for more
information.
GEA00952
– 25 –