Table of Contents
Advertisement
Airflow (Cabinet Interior)
The freezer compartment is designed so that
when the evaporator fan is operating, air is drawn
into the bottom of the air tunnel and through the
evaporator. The cold air is then pushed out into
the top of the freezer.
The fresh food compartment receives chilled air
via an electronic damper positioned at the top, rear
of the refrigerator between the freezer
compartment and the fresh food compartment.
The damper is controlled by the main control
board and when open, allows chilled air from the
freezer air tunnel to move into the fresh food
compartment.
Air returns from the fresh food compartment to the
freezer compartment via a vent located to the left
of the FRESH PRODUCE drawer.
"Jelly Roll" Condenser
The new NO CLEAN condenser is accessed from
the rear and is designed to be tolerant of up to 2
inches of lint. The idea is that the consumer, in
normal operating conditions, will never have to
clean the condenser. If necessary, only an
ordinary appliance brush is used. Air is drawn in
from the outside diameter of the condenser and
pulled out by the condenser fan. A condenser fan
baffle is located at the rear to direct airflow through
the condenser. Functionally, the condenser does
the same job as previous models. Air is drawn in
from front left and rear left and exits out front right
side of refrigerator.
– 11 –
Advertisement
Chapters
Table of Contents
