Update The Software - NETGEAR PTV3000 User Manual

Update the Software

NETGEAR recommends that you update the Push2TV adapter software as new updates
support even more wireless display devices.

To update the firmware:
1. Use you laptop, tablet, or smartphone to visit the NETGEAR Push2TV site software
update site at http://www.netgear.com/landing/stream/tv/#push2tv.
Note: If you cannot find a software update, visit the NETGEAR Download
Center at http://downloadcenter.netgear.com
PTV3000.
2. Download the software update.
3. Press and hold the WPS button on the side of the Push2TV adapter for about 7 seconds
until the LED on the front panel starts blinking.
WPS button
4. On your laptop, tablet, or smartphone, use the wireless network utility to find and connect
to the Push2TV WiFi network name (SSID).
5. Open a browser on your laptop, tablet, or smartphone.
You are automatically redirected to the Push2TV update page.
6. (Optional) If you are not automatically redirected, type http://192.168.3.1 into the browser
address bar.
7. Follow the steps on the web page to upload the software that you downloaded in
complete the installation.
Note: For information about updating Intel WiDi software on your laptop,
visit http://www.intel.com/go/wirelessdisplayupdate.
You are now ready to connect with Intel WiDi or with Miracast.
Push2TV Wireless Display Adapter PTV3000
Set Up the Push2TV Adapter
8
and enter the model number
Step 1, and