HP ProLiant BL680c Specification page 4
Hp proliant bl680c generation 7 (g7) server blade
Hide thumbs
Also See for ProLiant BL680c:
- User manual (111 pages) ,
- Configuration (23 pages) ,
- Introduction manual (13 pages)
Table of Contents
Advertisement
QuickSpecs
Standard Features
Network Controllers
I/O Expansion Slots
Six (6) embedded HP NC553i 10Gb FlexFabric adapter ports supporting autosensing 10Gb/1Gb Ethernet,
FCoE, Flex-10, TCP/IP offload engine, hardware-based accelerated iSCSI, and iSCSI boot
One Ethernet-specific slot (mezzanine slot 6) supporting a dual-port mezzanine card for a total of eight (8)
"embedded" Ethernet adapter ports
NOTE: Fibre Channel over Ethernet (FCoE) capability requires the use of an HP Virtual Connect FlexFabric
10Gb/24-port Module or HP 10GbE Pass-Thru Module.
NOTE: The Flex-10 capability requires the use of an HP Virtual Connect Flex-10 10Gb Ethernet module or
HP 10GbE Pass-Thru Module.
One (1) 10/100 network adapter port dedicated to iLO 3 Management
Seven (7) mezzanine expansion slots as follows:
Four (4) Type II (25 watts) x8 PCIe Gen2, mezzanine slots 2, 3, 4, 7 supporting QDR IB, 4Gb and 8Gb
FC, 10Gb FlexFabric, 10Gb Flex10, 10GbE, 1GbE, and the Smart Array RAID controllers.
Mezzanine slots 2 and 7 ports are routed to interconnect bays 5,6,7,8 (c7000 Enclosure) and
3,4,3,4 (c3000 Enclosure)
Mezzanine slots 3 and 4 ports are routed to interconnect bays 7,8,5,6 (c7000 Enclosure) and
3,4,3,4 (c3000 Enclosure
Two (2) Type I (15 watts) x4 PCIe Gen2, mezzanine slots 1 and 5 supporting 4Gb and 8Gb FC,10Gb
FlexFabric, 10Gb Flex10, 10GbE , and 1GbE
Mezzanine slots 1 and 5 ports are routed to interconnect bays 3, 4, 3, 4 (c7000 Enclosure) and
2,2,2,2 (c3000 Enclosure)
One (1) Type I (15 watts) x8 PCI Gen 2 dual-port Ethernet-specific slot (mezzanine slot 6)
Mezzanine slots 6 ports are routed to interconnect bays 1, 2 (c7000 Enclosure) and 1, 1
(c3000 Enclosure)
NOTE: This Ethernet-specific mezzanine slot allows the customer to decide if the additional
7th and 8th "embedded" Ethernet ports are desired and allows them to choose between
dual-port 10Gb FlexFabric, 10GbFlex-10, 10GbE, or 1GbE per the Ethernet mezzanine
adapters listed in the "Additional Options" section.
NOTE: HP recommends 10Gb adapters be installed in a x8 PCIe slot for optimal performance.
NOTE: Type II slots accept both Type I or Type II cards. Type I slots accepted Type I cards only.
DA - 13742 North America — Version 35 — December 13, 2013
HP ProLiant BL680c Generation 7 (G7) Server Blade
Page 4
Advertisement
Table of Contents
