Configuration Information - Factory Integrated Models - HP ProLiant BL680c Specification

QuickSpecs

Configuration Information - Factory Integrated Models

NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on Factory
Integrated Model product offerings and requirements.
NOTE: HP does not allow factory integration of options into standard models listed above.
Configure-to-order servers must start with a Factory Integrated Model (CTO) Blade.
NOTE: FIO indicates that this option is a Factory Installable Option.
Step 1: Base Server Blade Configuration (Select a configurable Blade)
HP Models HP ProLiant BL680c G7 W Configure-to-order Server
Configurable model ships with:
Six (6) embedded HP NC553i 10Gb FlexFabric adapter ports supporting autosensing
10Gb/1Gb Ethernet, FCoE, Flex-10, TCP/IP offload engine, hardware-based accelerated
iSCSI, and iSCSI boot
One (1) 10/100 network adapter port dedicated to iLO 3 Management
One (1) Integrated SAS version 2.0 (6Gb) HP Smart Array P410i Controller with RAID 0
and 1
NOTE: The P410i is configured with no cache allowing the end user to select the desired
cache option (if cache is desired in the first place). This provides RAID 0, 1 and 1+0 in the
standard configuration. However, options are available to add RAID 5 and 6; see the
"Optional Upgrades" section for P410i options.
NOTE: RAID 0, 1, and 1+0 are supported on the P410i without the need for a cache
option.
Four (4) slots for battery cache options.
NOTE: The server supports up to a combined total of four (4) battery cache options for
the P410i and/or optional Smart Array RAID controllers.
Four (4) small form factor hot-plug SAS/SATA/SSD hard drive bays
Seven (7) I/O expansion slots: six general purpose, and one Ethernet-specific for an
additional two "embedded" Ethernet ports
One (1) integrated Lights-Out 3
Integrated USB, MicroSDHC, and TPM connectors
DA - 13742 North America — Version 35 — December 13, 2013
HP ProLiant BL680c Generation 7 (G7) Server Blade
643785-B21
Page 16