Calibrate; Updates - Numark DDS80 Reference Manual

Calibrate

This function is used to calibrate the pitch sliders. Your DDS
has been pre-calibrated at the factory, but the characteristics
of the sliders may change slightly over time. If the top, center
and bottom positions no longer align with the expected pitch
range you should run this calibration routine.
Select Calibrate, then when prompted:
1. Move both sliders to the fully upward position (to the -
% symbol)
2. Select Next
3. Move both sliders to the center position
4. Select Next
5. Move both sliders to the fully downward position (to the +% symbol)
6. Select Next
Calibration is now complete. Press the Utility button to exit.
Note: If you mix up the calibration procedure by swapping over the minus and plus ends of the
scale, the pitch slider will have no effect! Simply re-run the calibration.

Updates

The Updates page shows the current software version of
the DDS. Please check
for available software upgrades.
software upgrade on the website is higher than the version
of the current software on your DDS, please follow the
upgrade procedure outlined in the next section of this
manual.
http://www.numark.com
If the version of the
NEXT
NEXT
NEXT
regularly
33