Display; Calibrate; Licenses - Numark HDMIX Reference Manual

Hard drive mixing station

Hide thumbs Also See for HDMIX:

Table of Contents

Display

From here the display brightness can be adjusted.

Also, a scale of shades from black to white is shown on

screen as an aid to setting the display contrast. Adjust the

contrast by rotating the Display Contrast knob located to

the left of the display until the left most segment of the scale

is black, the right most is white, and three shades can be

identified in between.

This function is used to calibrate the pitch sliders. Your

HDMIX has been pre-calibrated at the factory, but the

characteristics of the sliders may change slightly over time. If

the top, center and bottom positions no longer align with the

expected pitch range you should run this calibration routine.

Select Calibrate, then when prompted:

Move both sliders to the fully upward position (to the -

% symbol)

Select Next

Move both sliders to the center position

Select Next

Move both sliders to the fully downward position (to the +% symbol)

Select Next

Calibration is now complete. Press the Utility button to exit.

Note: If you mix up the calibration procedure by swapping over the minus and plus ends of the

scale, the pitch slider will have no effect! Simply re-run the calibration.

This screen displays the licensing information for the

HDMIX's parts and software.

Table of Contents